A round edge PVC edging trim - This profile features a small quadrant face which is good for 3 dimensional alignment, overhang lips to better butt against the cushion edge of the ceramic tile and a second upright support to close the face and make it suitable for floor tile use. Injection Moulded corner pieces to compliment the profile eliminating the need for mitring - for the perfect finish. Wide range of colours offered in contract packs of 100 or retail 4 pcs per Blister pack.
UPVC is particularly suitable for a wide range of application due to its excellent chemical resistance, however note the following: Not recommended for use above 60°C resistant to most oils, alcohols, petrol and fats. It is unsuitable for use in contact with aromatic and chlorinated hydrocarbons, ketonesm nitrocompounds, esters and cyclic ethers with cause some swelling.
Installation : 1) Check the exact position of the trim required relative to the tiles to be laid. 2) Bed trim intro normal tile adhesive ensuring adhesive penetrates the holes in the flange. There are 5mm holes available for mechanical fixing if additional securing is needed. 3) Spread the adhesive over the flange and firmly bed in tiles butting against the profile. 4) A grout gap is not necessary, however, it a gap is visible ensure grout is compressed firmly into the gap.
- Genesis ETR requires no special maintenance. Cleaned periodically using an neutral detergent to maintain the appearance.
- Regular cleaning aids the longevity of the profile and ensures there is no corrosion that could affect safety.