Pipe Cowl 15mm Copper
The Quickest, Neatest, Simplest and Lowest Cost installation solution for the pressure relief termination.
Just solder the cowl onto a short length of copper pipe and push through a pre-drilled hole in the brickwork. From the inside simply pull inwards until the cowl is a loose fit against the brickwork and cut to length. There is no fabricating to make outside, particularly useful at higher levels. Architects choose the Pipe Cowl because it has a neat installed finish that is guaranteed to be consistent on every installation, no matter which contractor is used. It is unobtrusive and does not offend the look of the building or create an obstruction, no matter where it is fitted.
Features and Benefits:
- Flowflex Copper 5000 Series Fittings Manufactured To En 1254-1: 1998
- Working Pressure 16 Bar 10 Bar 6 Bar
- Working Temperature - 40c To +30c +65c +110c
- Manufactured to EN 1254 and fully complies with all current legislation
- NHBC Approval
- Length: 40mm
- Cowl Dia: 28mm
- Patent No's:
- Europe - EP 1429 074A
- Britain - GB 2 396 204A